Bumper Jack Hold Down

RIP OLDS
Senior Member

Posts: 890

Bumper Jack Hold Down Jul 20, 2019 14:50:40 GMT -5

Quote

Post by RIP OLDS on Jul 20, 2019 14:50:40 GMT -5

I picked up the hold down bracket everyone sells, but it doesn't seem to fit the T style jack bar. Anyone have any idea how this should work? This is the only style bracket I have seen, and looks to be the same as the assembly manual. Is this only for the tube style bar?

www.ebay.com/i/350411843280?chn=ps&norover=1&mkevt=1&mkrid=711-117182-37290-0&mkcid=2&itemid=350411843280&targetid=541454196612&device=c&mktype=pla&googleloc=9004506&poi=&campaignid=1881946470&mkgroupid=74094014870&rlsatarget=pla-541454196612&abcId=1139336&merchantid=131376503&gclid=CjwKCAjw98rpBRAuEiwALmo-yr8tb5S_P5HumwdPGWrYRA4jZC6HDTVW4NdOkPNjBzYp5JsHukk2TBoC5ZQQAvD_BwE

familyrides1965 Senior Member Posts: 712	Bumper Jack Hold Down Jul 20, 2019 22:32:35 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by familyrides1965 on Jul 20, 2019 22:32:35 GMT -5 If you look at the home page for this site you will see the build manuals. Look at part 8 section 10. Figure 10.2.1

RIP OLDS
Senior Member

Posts: 890

Bumper Jack Hold Down Jul 21, 2019 7:34:15 GMT -5

Quote

Post by RIP OLDS on Jul 21, 2019 7:34:15 GMT -5

Thanks for the reply. I saw that, but I am talking about the actual hold down clamp and how it clamps the "T shaped" jack bar. The clamp doesn't seem to close enough to tighten down onto the bar. The picture you reference actually shows the tubular shaped bar.

Post by RIP OLDS on Jul 20, 2019 14:50:40 GMT -5

Post by familyrides1965 on Jul 20, 2019 22:32:35 GMT -5

Post by RIP OLDS on Jul 21, 2019 7:34:15 GMT -5