|
Post by RIP OLDS on Mar 7, 2017 21:31:10 GMT -5
|
|
|
Post by sascha on Mar 9, 2017 2:06:59 GMT -5
good job, looks fine! Gonna do it the same way when I take out the engine this year.
This is a 350 trans right?
Sascha
|
|
|
Post by RIP OLDS on Mar 9, 2017 20:45:51 GMT -5
TH400
|
|
|
Post by oldstata on Mar 9, 2017 23:12:24 GMT -5
Th400 9.5 inch tail shaft? If so what is your drive line length and what rear end are you running ?
Ps looks awesome great work
|
|
|
Post by sascha on Mar 10, 2017 1:56:17 GMT -5
so this is the TH 400 with the long housing/tailshaft at the end.
I assume you had to adapt the position of the trans mount/cross bar and for sure the tail shaft is custom made right?
|
|
|
Post by oldstata on Mar 10, 2017 9:19:33 GMT -5
so this is the TH 400 with the long housing/tailshaft at the end. I assume you had to adapt the position of the trans mount/cross bar and for sure the tail shaft is custom made right? Trans mount needs to be moved back 6 inches or so holes would need to be drilled There is 3 tail shaft lengths for the th400 from factory Can't remember exactly the lengths but some thing around theses A body's 4" inch B body 9" Trucks ? 13"
|
|
|
Post by RIP OLDS on Mar 10, 2017 22:22:09 GMT -5
Tranny mount was moved back, and the drive shaft was shortened.
|
|
|
Post by oldstata on Mar 11, 2017 0:30:27 GMT -5
Tranny mount was moved back, and the drive shaft was shortened. Do you know what the total length was after they shortened it ? I am about to do this same swap also do you still Have the 65 rear end ?
|
|
|
Post by RIP OLDS on Mar 12, 2017 9:02:51 GMT -5
Same stock rear end. I have to go into the garage today even tho it's 15 degrees. I'll see if I can measure it. According the code on my TH400, it is from a Buick powered by a 455. I'll measure the tail end as well.
|
|
|
Post by RIP OLDS on Mar 12, 2017 10:57:44 GMT -5
The tail on the TH400 is 9-1/2 inches. I could not get a very accurate measurement on the drive shaft, but the length of the tube part was about 51 inches.
|
|
|
Post by oldstata on Mar 12, 2017 19:50:20 GMT -5
Thanks same trans but I am going to be installing a 12 bolt olds so not sure if the length would be the same was hoping you were running the same set up so I could just run down and have mine made
|
|