|
Post by RIP OLDS on Jul 19, 2009 20:11:21 GMT -5
Okay, so in addition to my issue under the Thread "Courtesy Lights", I have the following problem.
I should preface this by saying that my Turn Signals used to work. Now when I turn on the left or right turn signal the interior green lights on the Spedo stay on steady. This usually means a bad Front/ Rear bulb.
All bulbs are good so here what is going on.
1 - Front Parking Lights do not go on when the headlight switch is in the parking light position. I get no voltage to either socket. Rear Lights work.
2 - When I turn on the Right Turn Signal (Pass side), No voltage to lamp socket (or the lead wires to its connector).
3 - When I turn on the Left Turn Signal, I get 12 V to lamp socket but the bulb does not go on.
Obviously tuff to diagnose on the net but maybe someone once had a similar problem. Very frustrating!
If the Left Turn Signal socket is defective (open circuit), and doesn't make proper contact with the bulb, would that kill the Right socket since the left socket is first in the circuit?
Does anyone sell replacement sockets for the front lamps?
|
|
|
Post by BR[] on Jul 20, 2009 6:49:19 GMT -5
1st question........ is this a tilt wheel? That sliding turn signal switch can be a pain. 2. Have you tried a new turn signal switch
You cant buy the new sockets, but you can get the interior parts from napa , advanced or others.
|
|
|
Post by RIP OLDS on Jul 20, 2009 19:14:07 GMT -5
It's not a tilt steering column, and I have not tried a new turn signal switch. I was trying not to buy parts hoping it would solve the problem.
"You cant buy the new sockets, but you can get the interior parts from napa , advanced or others."
Which parts specifically are the interior parts?
|
|