|
Post by oldsproject on Nov 8, 2009 21:48:54 GMT -5
As I get prepared to start the frame work was looking at your brake line work (which is really nice). Question though..... Your picture shot of the tear down shows the brake line going around the drivers motor mount then behind the front crossmember to the passenger brake. Your finished brake line goes around both motor mounts. Which is correct
|
|
|
Post by RAM Z on Nov 8, 2009 21:58:53 GMT -5
The original line on the car went around the drivers mount then behind the other. The assembly manual calls for the line to run that way. My lansing parts car had the line around both and the repop line I used was like that too. So I guess that doesnt solve anything.
|
|
|
Post by oldsproject on Nov 8, 2009 22:46:11 GMT -5
Unless other opinions, I'll go with the way yours was and the assembly manual. Doesn't seem to make sense to go around both?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 10, 2009 11:01:17 GMT -5
I almost copied RamZ's cause I liked the way it looked, but when I looked at the Manual, it showed what Ramz stated. And, after several attempt to do the dual lines like his, I gave up and stuck with the manual. I didn't know that you could buy them pre- bent.
|
|
|
Post by RAM Z on Nov 12, 2009 16:58:43 GMT -5
|
|