|
|
Post by gottago on Nov 3, 2023 21:05:46 GMT -5
I'm replacing my belt line or outer window sweeps and interior fuzzies. This is on a 65 442 Post/Club Coupe, I have a set from PUI, fuzzies work well, clips into place, but exterior dont line up with tabs on molding. I'm ending up drilling holes and using screws, just does not look good. Anyone have experience with these or other brands, what works??
|
|
|
|
Post by looney1 on Nov 8, 2023 9:31:48 GMT -5
I asked a similar question a while back. Never got an answer. Apparently no one on here uses sweeps. The ones I have , have the notches cut too big.
|
|
|
|
Post by gottago on Nov 13, 2023 11:40:06 GMT -5
How are you securing the rubber sweeps? I've drilled holes and screwed but still wavy.
|
|
|
|
Post by looney1 on Nov 16, 2023 19:28:59 GMT -5
I haven't found any to my liking yet so I haven't tried to fasten anything yet. Was gonna check with Steele and see if they would sell just the ones for the doors rather than having to buy the whole set.
As for your original question. I don't think I would be drilling extra holes. There's gotta be a better product out there.
|
|
