|
Post by john442 on Oct 26, 2020 9:52:30 GMT -5
Does anyone know if the KH power steering pulley is available from parts houses? Mine seems to be making a noise and is wobbling some. I removed the belt just to make sure the noise was coming from the pump or pulley and the noise disappeared. I can move the pulley slightly from side to side. I tried to tighten the bolt holding the pulley in place and it seemed loose and but would not tighten. Possible stripped.
|
|
|
Post by joepadavano on Oct 26, 2020 18:11:10 GMT -5
More likely the bushing in the nose of the housing that the shaft rides in is shot.
|
|
|
Post by john442 on Oct 27, 2020 13:54:27 GMT -5
Joe I too was thinking it might be the pump bearing and not the pulley. I will remove the pulley and inspect the pump shaft to check for play. I ordered a new KH pulley with washer and nut from inline tube. The used pulley I had had a slight wobble
The pump is new and was installed last year because the old pump was leaking. I used the right spacers and could not get the alignment perfect but close to it. I suspect that the slight misalignment and pulley wobble may have caused the bearing in the pump to wear. If the pump bearing is bad I will replace the pump with a new one.
|
|
|
Post by john442 on Oct 29, 2020 13:47:11 GMT -5
I installed the new pulley and believe the problem was with the old pulley.
|
|