|
Post by mongoose on Sept 19, 2012 6:03:46 GMT -5
I want to do some additional tuning on my Proform/Quick Fuel carb by adjusting the idle feed restrictors, idle and high speed air bleeds.
"Problem" is, to have a wide range of sizes available to be able to make the adjustments, a kit will cost somewhere around $200 (just for the idle and high speed bleeds). And ultimately you only use 8 of those bleeds (about $10 worth).
Does anyone have a kit I can borrow? It sounds cheap (and I guess I am in this case), but it seems silly to buy over $200 of stuff when I'm actually only going to use $10 worth of it. But since the process of determining size will be quite a bit trial and error, I don't think there's a way around not having a wide range of sizes to try.
|
|
|
Post by mongoose on Oct 20, 2012 10:07:00 GMT -5
I ended up buying a few packages of blank restrictors and feeds, and drill them to size as needed. For the most part, I just start out too small, and gradually increase the size until it starts to act like it's too big, then I make another for the size it seems to respond to best.
|
|