|
|
Post by mongoose on Aug 29, 2011 7:11:43 GMT -5
$1,000, plus shipping (probably $100 to ship all) "C" Heads- Ported by Mike Yelvington, formerly with Reher-Morrison
- Stainless Steel Valves: 2.072" intake, 1.625" exhaust
- Hardened exhaust valve seats
- 7/16" studs and guide plates for 3/8" pushrods
- Dual valve springs (up to .600" lift), moly retainers and keepers
- Bronze guides, milled for teflon valve seals
Torker Intake- Ported by Mike Yelvington, formerly with Reher-Morrison, to match heads
Aluminum Roller RockersObviously everything needs to be cleaned up (tanked or media blasted), but all is in good working order. All this fit under a stock valve cover (I had removed the oil baffles, but don't know that I needed to).        |
|
|
|
Post by mongoose on Sept 14, 2011 5:29:13 GMT -5
Minor specification correction:
Rocker studs are 7/16", not 3/8".
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 14, 2011 17:22:08 GMT -5
Minor specification correction: Rocker studs are 7/16", not 3/8". You originally said 7/16, but this will put your post back up top. The vette guy should buy these, just what he needs |
|
|
|
Post by mongoose on Sept 14, 2011 19:31:10 GMT -5
I corrected the post, so new readers would see the correct spec, then I highlighted the change with a new post for those that already read it, in case that would make any difference in their interest.
I agree about the new vette guy... but it sounds like he wants to go the same route as me and go with the aluminum heads.
|
|
|
|
Post by real57vetteguy on Sept 21, 2011 11:59:08 GMT -5
I corrected the post, so new readers would see the correct spec, then I highlighted the change with a new post for those that already read it, in case that would make any difference in their interest. I agree about the new vette guy... but it sounds like he wants to go the same route as me and go with the aluminum heads. I am leaning towards the Aluminums. And if I wanted some extensive port/polish work done its a bit less pricey! |
|
|
|
Post by mongoose on Jan 12, 2012 7:08:36 GMT -5
We've added a lot of new members over the last few months, so I thought I'd bring this post back up.
I had these sold, and the night before I was going to drive to meet the guy buying them, he got a great deal on a set of aluminum heads, and I don't blame him on that.
Since then I haven't been proactive to get them back on the market.
|
|
|
|
Post by 1965f85 on Jan 14, 2012 11:05:05 GMT -5
@ Mongoose..... Have you had these heads flo tested? If so, can you tell me what they're flowing? Much appreciated.
Ted
|
|
|
|
Post by mongoose on Jan 15, 2012 7:01:50 GMT -5
No unfortunately I never did... but it is definitely a good question to ask.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 17, 2012 22:56:03 GMT -5
Mark I thought the 455 you bought has some really cool ported aluminum heads??
|
|
|
|
Post by mongoose on Jan 18, 2012 5:36:21 GMT -5
Mark I thought the 455 you bought has some really cool ported aluminum heads?? His post above was made before he had bought the 455. |
|
