|
Post by 64b09 on Feb 2, 2011 0:17:45 GMT -5
The metal trim pieces that are both sides of the rear seat back, and also the rear seat metal armrests for a non convert? I have new vinyl covers for the armrest but the metal is rusty around the lower edges. I suppose I could weld in some new stuff, but new would be ok too. I can't seem to find the trim pieces for the sides of the seat back, must have lost them somewhere.
|
|
|
Post by RAM Z on Feb 2, 2011 8:11:21 GMT -5
I have two rear seat filler pieces, pay for the ride and they are yours.
The rear arm rest panels are not being made, I have those pieces too.
|
|
|
Post by 64b09 on Feb 2, 2011 12:21:52 GMT -5
That would be awesome. Sending PM.
|
|
|
Post by alldun5 on Feb 2, 2011 13:38:24 GMT -5
64b09 your avatar is awesome, where did you find it?
|
|
|
Post by 64b09 on Feb 2, 2011 19:35:08 GMT -5
Found it online. Its from a 64 442 road test. I think it was the motor trend one. I have the mag but google saved me from scanning it. ;D
|
|
|
Post by alldun5 on Feb 2, 2011 20:04:10 GMT -5
found it.
|
|
|
Post by yammiman on May 6, 2017 13:00:55 GMT -5
Are the rear arm rest panels the same size on the coupes and convertibles? - looking at pictures, they appear to be
|
|
|
Post by yammiman on May 10, 2017 10:05:03 GMT -5
Anyone know the answer to this?
|
|
|
Post by RAM Z on May 10, 2017 10:34:44 GMT -5
no
|
|
|
Post by yammiman on May 15, 2017 14:42:20 GMT -5
Are the base's metal or hardboard? - does anyone reproduce them?
|
|
|
Post by yammiman on May 16, 2017 8:17:04 GMT -5
Anyone know on this one?
|
|
|
Post by RAM Z on May 16, 2017 9:59:57 GMT -5
Sheet metal not reproduced.
|
|
|
Post by yammiman on May 16, 2017 10:39:06 GMT -5
thanks
|
|
|
Post by yammiman on May 16, 2017 10:52:35 GMT -5
Could ones from a convertible be modified to work?
|
|
|
Post by stan65cutlass on May 16, 2017 13:14:40 GMT -5
i do know the convertible seats are a different width at that point so im sure the size is quite different
|
|