|
Post by RIP OLDS on May 17, 2019 6:10:20 GMT -5
Question on the two rear control arm (Uppers) bushings that are pressed into the rear axle ear bracket. The two I removed, which appeared to be original, had the bushing flange spaced about 1/4 inch from the face of the axle bracket.
Is this the correct position ? One would think the flange should sit flush to the bracket.
|
|
|
Post by joepadavano on May 17, 2019 8:25:03 GMT -5
Same answer I gave you over at ClassicOlds...
|
|
|
Post by RIP OLDS on May 17, 2019 20:00:21 GMT -5
Thanks Joe, makes sense, didn't realize the openings on the axle ears are smaller than the control arms so the entire bushing needs to be pressed in, not just the bumped out part near the flange.
|
|